Bondtech CHT Vol Coated Brass Nozzle - 0,6 mm -1 pcs

• Higher melt capacity by increasing the surface area of the heating walls
• Flow Rate gains close to 50%
• Competitive price/performance price
• Machined with ultra-precision
• Brass nozzle with Nickel coated surface
• Follows nozzle standard: Volcano (M6×1×14.5×21)
• May be used with 1.75 or 2.85mm hotends.

Flow Rate gains may vary. Results depend on the hardware, materials and print settings used.

Bondtech CHT® nozzles split the filament into 3 thinner strands allowing to melt the material from within. In doing so, the material melts faster and higher flow rates can be used.

Registration number: EP3445568A1 Nozzles for 3D printers made of metal with at least one or a multitude of holes to increase the surface area of the heating walls.

A Nickel coating is applied to our Coated Brass nozzles to provide protection against corrosion, erosion, and abrasion. Nickel coated nozzles have more corrosion resistance and lower coefficient of friction, which allows slicker feeding of material and delays plastic adhesion to the nozzle's surface.

Use this nozzle with the following materials:

• PLA
• ABS
• HIPS
• PC
• TPU
• TPE
• Nylon
• PETG
• ASA
• PP
• PVA

For technical and abrasive materials we recommend to use other nozzles in our range.

We recommend you to have several sets of nozzles because:

• Using different materials with the same nozzles causes deposit build-up inside the nozzle.
• These deposits will cause blockages.
• We recommend changing nozzles when changing materials.